Nemco 55650-3 1/2" x 1/2" Square Easy LettuceKutter

To change a blade set on the Nemco Easy Lettuce Cutter is actually very simple. First thing you’ll do is take this pin. Then you’re going to lift this handle, and you’re going to line up the holes in the back of the handle, and you’re going to insert this pin. Right like that. That’s going to hold your pusher block up and out of your way. You’ll notice that there are these two clips on either side of the base of the guideposts. What you’re going to do is grab them down here (there is a little place to grab them) and you can just pop them like that, and they come right off very easy. And then you’re going to take the blade set and pull it up off of the pins, being very careful because these blades are sharp, and you can take it off and replace it with a new blade set. If you want to change the actual blades, you’ll see there are screws right here. You can unscrew those and then follow the instructions that come with the blades. To reattach, you just line your holes up with the little pins, and you can just takes these clips, push them down, push these stoppers down, and there you are! It’s as easy as that to change the blades on the Nemco Easy Lettuce Cutter.